Add a Logical System
You are here: Configure > Multi Tenancy > Logical Systems.
To add a logical systems:
- Click the add icon (+) on the upper right side
of the Logical Systems page.
The Create Logical Systems page appears.
- Complete the configuration according to the guidelines provided in Table 1.
- Click Finish to save the changes. If you want to discard your changes, click Cancel.
Table 1: Fields on the Add Logical Systems Page
Enter a logical system name of a selected Resource Profile. Only one Resource Profile can be selected, per logical system.
The string must contain alphanumeric characters, colons, periods, dashes, and underscores. No spaces are allowed; maximum length is 63 characters.
|Logical System Resource Profile|
Enter a name of the security profile.
The string must contain an alphanumeric character and can include underscores; no spaces allowed; 31 characters maximum.
Select an IPS policy from the list.
Displays the resource name.
Display range for each resource.
Select a resource and click on the pencil icon to edit Reserved and Maximum fields.
Specify reserved quota that guarantees that the resource amount specified is always available to the logical system.
Specify the maximum allowed quota.
IPS Max Sessions
Enter maximum number of sessions. Use up and down arrow keys to increase or decrease the number.
Enter a user name.
Maximum length is 64 characters.
Enter a password for the user which is more than 6 characters but less than 128 characters.
Re-enter the new password to confirm.
|Create-Edit logical interfaces|
Physical Interface Name
Displays the name of the Physical Interface.
Logical Interface Unit
Enter the logical Interface Unit
Enter the description.
Enter the VLAN ID. VLAN ID is mandatory.
Click + and enter a valid IP address.
Enter a valid subnet mask.
Select the IPv4 address and click the delete icon to delete the address.
Enter a valid IP address.
Enter a valid subnet mask.
Select the IPv6 address and click the delete icon to delete the address.
|Create-Edit Security Zones|
Enter a valid name of the zone.
Enter a description of the zone.
Enables the application tracking support.
Source Identity Log
Enable source identity log for this zone.
Select an interface from the Available column and move it to Selected column.
Displays the selected interfaces.
Select system services from the following options:
Note: Select the Except check box to allow services other than the selected services.
Select a protocol from the following options:
Note: Select the Except check box to allow protocols other than the selected protocols.
Traffic Control Options
Enable this option to send RST for NON-SYN packet not matching TCP session.