Add a Link Aggregation
You are here: Configure > Interfaces > Link Aggregation.
To add a link aggregation:
- Click the add icon (+) on the upper right side
of the Link Aggregation page.
The Create Link Aggregation page appears.
- Complete the configuration according to the guidelines provided in Table 1.
- Click OK to save the changes. If you want to discard your changes, click Cancel.
Table 1: Fields on the Create Link Aggregation Page
Enter the aggregated interface name.
Note: If an aggregated interface already exists, then the field is displayed as read-only.
Select the interface available for aggregation and move to Selected column using right arrow.
Note: Only interfaces that are configured with the same speed can be selected together for a LAG.
Specifies global Link Aggregation Control Protocol configuration.
Select a mode in which Link Aggregation Control Protocol packets are exchanged between the interfaces. The modes are:
Select a periodic transmissions of link aggregation control PDUs occur at different transmission rate. The options available are:
Click the arrow button to select the priority level that you want to associate with the LAG.
Enable or disable the option to protect the link.
Note: You can configure only two member links for an aggregated Ethernet interface, that is, one active and one standby.
Enable or disable the option to not to choose even if a higher priority link is available.
Enter a description for the LAG.
Enable or disable VLAN tagging for a LAG.