Help us improve your experience.

Let us know what you think.

Do you have time for a two-minute survey?

Navigation
Guide That Contains This Content
[+] Expand All
[-] Collapse All

    Configuring Routing in the Core Network for VPLS

    After you configure the transparent bridging, LDP, and MPLS components of the VPLS network, you must configure an IGP, such as OSPF or IS-IS, on the PE router to set up routing within the core MPLS network.

    This section explains one way to configure OSPF to enable routing in the core network.

    Table 1 lists the commands discussed in this section to configure OSPF.

    Table 1: Commands to Configure OSPF for a VPLS Network

    network area

    router ospf

    To configure the PE router to set up OSPF routing for the core MPLS network:

    1. Create the OSPF routing process.
      host1(config)#router ospf 1
    2. Create the range of IP addresses associated with the routing process and the corresponding OSPF interfaces, and assign an area ID associated with each range of IP addresses.
      host1(config-router)#network 10.1.1.1 0.0.0.0 area 0.0.0.0 host1(config-router)#network 10.10.10.0 0.0.0.255 area 0.0.0.0

      This example configures an OSPF routing process with process ID 1, and creates two OSPF interfaces in the backbone area (area 0.0.0.0): one using IP address 10.1.1.1, and one using IP address 10.10.10.0. The network area commands create the two OSPF areas if they do not already exist.

    For complete information about configuring and using OSPF and IS-IS, see the JunosE IP, IPv6, and IGP Configuration Guide.

    Published: 2014-08-18