Help us improve your experience.

Let us know what you think.

Do you have time for a two-minute survey?

Navigation
Guide That Contains This Content
[+] Expand All
[-] Collapse All

    Configuring a Parameter Definition for QoS Downstream Rate

    To associate a parameter instance with the QoS downstream rate application:

    1. Configure traffic classes.
      host1(config)#traffic-class voice host1(config-traffic-class)#exit host1(config)#traffic-class best-effort host1(config-traffic-class)#exit
    2. Create a parameter definition for the QoS downstream rate application.
      1. Configure the QoS parameter name and the application.
        host1(config)#qos-parameter-define downstreamVLAN application qos-downstream-rate
      2. Configure controlled-interface types.
        host1(config-qos-parameter-define)#controlled-interface-type vlan host1(config-qos-parameter-define)#controlled-interface-type ip
      3. Configure subscriber-interface types.
        host1(config-qos-parameter-define)#subscriber-interface-type vlan
    3. Do one of the following:
    4. Enable QoS adaptive mode for the system by issuing the qos-adaptive-mode command in L2C Configuration mode.
      host1(config)#l2c host1(config-l2c)#qos-adaptive-mode
    5. Enable the QoS downstream rate application to use downstream rates obtained from the Actual-Data-Rate-Downstream [26-130] DSL Forum VSA.
      host1(config)#aaa qos downstream-rate
    6. Configure the scheduler profile for the shaping rate.
      host1(config)#scheduler-profile vlan1 host1(config-scheduler-profile)#shared-shaping-rate downstreamVLAN * 5 auto
    7. Configure the QoS profile for the shaping rate.
      host1(config)#qos-profile vlan1 host1(config-qos-profile)#vlan node scheduler-profile vlan1
    8. Attach the QoS profile to a logical Ethernet interface.

      ANCP or AAA dynamically creates the parameter instances for the QoS downstream rate application, and if applicable, the QoS cell mode application; therefore, you do not need to specify them.

      host1(config)#interface gigabitEthernet 6/0/2 host1(config-if)#encapsulation vlan host1(config-if)#interface gigabitEthernet 6/0/2.1 host1(config-if)#vlan id 1 host1(config-if)#qos-profile vlan1 host1(config-if)#ip address 6.10.10.10 255.255.255.255

    For more information about configuring ANCP (L2C) parameters, see JunosE IP Services Configuration Guide.

    Published: 2014-08-11