Help us improve your experience.

Let us know what you think.

Do you have time for a two-minute survey?

Navigation
Guide That Contains This Content
[+] Expand All
[-] Collapse All

    Configuring IPv4 and IPV6 over static PPPoE with VLANs

    To configure IPv4 and IPv6 interface columns over static PPPoE with VLANs:

    1. Specify a Fast Ethernet, Gigabit Ethernet, or 10-Gigabit Ethernet interface.
      host1(config)#interface gigabitEthernet 2/0/1
    2. Specify VLAN as the encapsulation method.
      host1(config-if)#encapsulation vlan

      The VLAN major interface is added.

    3. Create a VLAN subinterface by adding a subinterface number to the interface identification command.
      host1(config-if)#interface gigabitEthernet 2/0/1.1
    4. Assign a VLAN ID for the subinterface.
      host1(config-if)#vlan id 1
    5. Create a PPPoE subinterface.
      host1(config-if)#pppoe
    6. Specify PPPoE as the encapsulation method on the interface.
      host1(config-if)#pppoe subinterface gigabitEthernet 2/0/1.1.1host1(config-if)#encapsulation ppp
    7. Specify the order of preference for the primary authentication protocol.
      host1(config-if)#ppp authentication pap chap eap
    8. Enable IPv6 processing on an interface without assigning an explicit IPv6 address to that interface.
      host1(config-if)#ipv6 unnumbered loopback 0
    9. Enable the IPv6 Neighbor Discovery process on an interface.
      host1(config-if)#ipv6 nd
    10. Specify which IPv6 prefixes the system includes in IPv6 router advertisements.
      host1(config-if)#ipv6 nd prefix-advertisement 2002:1::/64 60000 45000 onlink autoconfig
    11. (Optional) Configure additional VLAN subinterfaces by completing Steps 3 through 10.

    Published: 2014-08-14