Help us improve your experience.

Let us know what you think.

Do you have time for a two-minute survey?

Navigation
Guide That Contains This Content
[+] Expand All
[-] Collapse All

    Configuring IPv6 Hardware Multicast Packet Replication

    To configure hardware multicast packet replication:

    1. Configure port 8 on a high-density Ethernet module to accept redirected egress multicast traffic.
      1. Specify the Gigabit Ethernet interface on port 8.
      2. Create a VLAN major interface.
      3. Create a VLAN subinterface.
      4. Assign a VLAN ID.
      5. Configure an unnumbered IPv6 interface.
      6. Enable MLD on the interface with only multicast-data-forwarding capability.
        host1(config)#interface gigabitEthernet 2/8 host1(config-if)#encapsulation vlan host1(config-if)#interface gigabitEthernet 2/8.1 host1(config-if)#vlan id 1 host1(config-if)#ipv6 unnumbered loopback 0 host1(config-if)#ipv6 mld version passive
    2. Configure an IPv6 interface to redirect egress multicast traffic to port 8.
      1. Create a VLAN subinterface.
      2. Assign a VLAN ID.
      3. Assign an IPv6 address.
      4. Configure the interface to redirect egress multicast traffic to port 8.
        host1(config)#interface gigabitEthernet 2/0.101 host1(config-if)#vlan id 1 host1(config-if)#ipv6 address 1::1/64 host1(config-if)#ipv6 multicast ioa-packet-replication gigabitEthernet 2/8.1

    Published: 2014-08-20