Help us improve your experience.

Let us know what you think.

Do you have time for a two-minute survey?

Guide That Contains This Content
[+] Expand All
[-] Collapse All

    Removing Member Subinterfaces from a Circuit

    To remove a member subinterface from a circuit, either issue the no member interface command (from the L2 Transport Load-Balancing-Group Configuration mode) or issue the no mpls-relay command at the VLAN or S-VLAN subinterface level. Each of the following examples removes member Fast Ethernet subinterface 13/0.2 from the load-balanced Martini circuit:

    host1(config)#mpls l2transport load-balancing-group 100 mpls-relay 202 host1(config-mpls-l2-group)#no member interface fast 13/0.2


    host1()#interface fast 13/0.2 host1(config-subif)#no mpls-relay

    Published: 2014-08-18