Help us improve your experience.

Let us know what you think.

Do you have time for a two-minute survey?

Navigation
Guide That Contains This Content
[+] Expand All
[-] Collapse All

    Configuring Fragmentation and Reassembly for Dynamic MLPPP

    To configure fragmentation and reassembly for dynamic MLPPP, you must create a profile that includes commands to define the link and bundle attributes, just as you do for a static MLPPP configuration.

    For more information, see:

    To define a profile that configures MLPPP fragmentation and reassembly for a dynamic MLPPP interface:

    1. From Global Configuration mode, create a profile by assigning it a name, and access Profile Configuration mode.
      host1(config)#profile dynmlppp1 host1(config-profile)#
    2. Enable the creation of dynamic MLPPP interfaces.
      host1(config-profile)#ppp multilink enable
    3. Enable fragmentation on the link interface, and optionally specify the maximum allowable fragment size to use.
      host1(config-profile)#ppp fragmentation 128

      Note: You can specify the maximum fragment size for a link only when you use the ppp fragmentation command to enable fragmentation on that link. You cannot specify the maximum fragment size for a link when fragmentation is disabled.

    4. Enable reassembly on the link interface, and optionally specify the administrative MRRU value to use.
      host1(config-profile)#ppp reassembly 1800

      Note: You can specify the administrative MRRU value for a link only when you use the ppp reassembly command to enable reassembly on that link. You cannot specify the administrative MRRU for a link when reassembly is disabled.

    5. (Optional) Specify a virtual router to which dynamic IP interfaces created with this profile will be assigned.
      host1(config-profile)#ip virtual-router boston
    6. (Optional) Specify an IP loopback interface with which dynamic IP interfaces created with this profile will be associated.
      host1(config-profile)#ip unnumbered loopback 0
    7. (Optional) Set other PPP characteristics as needed by using the ppp commands. For more information about the ppp commands, see JunosE Command Reference Guide.

    Published: 2014-08-14