Help us improve your experience.

Let us know what you think.

Do you have time for a two-minute survey?

Navigation
Guide That Contains This Content
[+] Expand All
[-] Collapse All
     
     

    Configuring MPLS LSPs for VPWS

    This section explains one way to create a basic MPLS configuration using the mpls and mpls ldp commands.

    To configure MPLS LSPs on the PE router:

    1. Enable MPLS on the virtual router.
      host1(config)#mpls
    2. Configure the core-facing interface on which you want to enable MPLS, Label Distribution Protocol (LDP), and topology-driven LSPs.
      host1(config)#interface atm 5/0.100 host1(config-subif)#atm pvc 100 1 100 aal5snap 0 0 0 host1(config-subif)#ip address 192.168.5.5 255.255.255.0
    3. Enable MPLS on the core-facing interface.
      host1(config-subif)#mpls
    4. Enable LDP and topology-driven LSPs on the core-facing interface.
      host1(config-subif)#mpls ldp host1(config-subif)#exit

    For information about configuring MPLS, see Unresolved xref.

     
     

    Published: 2014-08-18