Help us improve your experience.

Let us know what you think.

Do you have time for a two-minute survey?

Navigation
Guide That Contains This Content
[+] Expand All
[-] Collapse All

    Before You Configure IPv6

    Before you configure IPv6, you must create the lower-layer interfaces over which IPv6 traffic flows. For information about the modules that support IPv6:

    • See E120 and E320 Module Guide, Appendix A, IOA Protocol Support for modules supported on E120 and E320 routers.
    • See ERX Module Guide, Appendix A, Module Protocol Support for modules supported on the ERX310, ERX710, ERX1410, and ERX1440 routers.

    For example, to configure an ATM interface:

    host1(config)#interface atm 1/0 host1(config-if)#atm sonet stm-1 host1(config-if)#no loopback host1(config-if)#atm clock internal chassis host1(config-if)#interface atm 1/0.10 host1(config-if)#atm pvc 10 0 20 aal5snap

    See JunosE Link Layer Configuration Guide for information about configuring an ATM interface. See JunosE Physical Layer Configuration Guide for information about configuring an Ethernet interface.

    Published: 2014-08-13