Help us improve your experience.

Let us know what you think.

Do you have time for a two-minute survey?

Navigation
Guide That Contains This Content
[+] Expand All
[-] Collapse All

    Adding a Host Route to a Peer on a PPP Interface

    You can enable the ability to create host access routes on a Point-to-Point Protocol (PPP) interface using the ip access-routes command. This feature is useful in B-RAS applications.

    Note:

    • Before you configure IP, you must create the lower-layer interfaces over which IP traffic flows.
    • All IP configurations will be removed from the interface when you issue the no ip interface command in Interface Configuration mode.

    To enable the ability to create host access routes on the PPP interface:

    • Issue the ip access-routes command in Interface Configuration mode.
      host1(config-if)#ip access-routes

      Use the no version to disable this feature.

    Published: 2014-08-13