Help us improve your experience.

Let us know what you think.

Do you have time for a two-minute survey?

Navigation
Guide That Contains This Content
[+] Expand All
[-] Collapse All

    Assigning a Previously Configured VC Class to a Base Profile

    You can use the atm class-vc command to assign a previously configured VC class to a base profile for a dynamic ATM 1483 subinterface. This command applies the set of attributes in the specified VC class to all bulk-configured VC ranges that are dynamically created from this base profile.

    You must issue the exit command from Profile Configuration mode for the VC class association to take effect.

    Note: Changes to a VC class specified in a base profile apply only to those PVCs that are dynamically created after the change is made. These changes do not apply to dynamic PVCs that were created prior to the VC class modification.

    To assign a previously configured VC class to a base profile for a dynamic ATM 1483 subinterface:

    • Issue the atm class-vc command in Profile Configuration mode.
    host1(config-profile)#atm class-vc gold-subscriber-class host1(config-profile)#exit

    Use the no version to remove the VC class association with the base profile.

    Published: 2014-08-14