Help us improve your experience.

Let us know what you think.

Do you have time for a two-minute survey?

Guide That Contains This Content
[+] Expand All
[-] Collapse All

    Configuring the Router to Work with the SRC Software

    E Series Broadband Services Routers have an embedded SRC client that interacts with the SRC software. For information about configuring the SRC client, see SRC Client Configuration Overview.

    Figure 1 shows the scenario for this example. Subscribers obtain access to ISP Boston via a router. Subscribers log in through the SRC software, and a RADIUS server provides authentication.

    Figure 1: Non-PPP Equal-Access Configuration Example

    Non-PPP Equal-Access Configuration Example

    The following steps describe how to configure this scenario.

    1. Configure interfaces on the router.
      host1(config)#interface loopback 0 host1(config-if)#ip address host1(config-if)#ip address secondary host1(config-if)#exit host1(config)#interface fastEthernet 2/0 host1(config-if)#ip unnumbered loopback 0
    2. Configure the parameters to enable the router to forward authentication requests to the RADIUS server.
      host1(config)#radius authentication server host1(config)#udp-port 1645 host1(config)#key radius
    3. Specify the authentication method.
      host1(config)#aaa authentication ppp default radius


      host1(config)#aaa authentication ppp default none
    4. Enable the DHCP local server.
      host1(config)#service dhcp-local
    5. Specify the IP addresses that are in use, so that the DHCP local server cannot assign these addresses.
      host1(config)#ip dhcp-local excluded-address host1(config)#ip dhcp-local excluded-address
    6. Configure the DHCP local server to provide IP addresses to subscribers of ISP Boston.
      host1(config)ip dhcp-local pool ispBoston host1(config-dhcp-local)#network host1(config-dhcp-local)#domain-name ispBoston host1(config-dhcp-local)#default-router host1(config-dhcp-local)#lease 0 0 10 host1(config-dhcp-local)#ip dhcp-local limit atm 5
    7. Configure the SRC client.
      host1(config)#sscc enable host1(config)#sscc retryTimer 200 host1(config)#sscc primary address port 3288

    Published: 2014-08-20