Navigation
Table of Contents
Guide That Contains This Content
[+] Expand All
[-] Collapse All
Enabling the Core Dump from Global Configuration Mode
To enable the core dump from Global Configuration mode:
- Access Global Configuration mode.
- Specify where the system should transfer the core dump
file. To send the file to an FTP server, enter the IP address of the
FTP server and the name of the directory on the server to which the
system will transfer the file. To send the core dump file to NVS memory,
use the local keyword. Local core dumps—stored in NVS—are
enabled by default.host1(config)#exception dump 192.168.56.7 CORE_DUMPS
- Set the IP address and mask of the system interface over
which you want to send the core dump file. You can optionally include
an IP address mask.host1(config)#exception source 10.10.33.8 255.255.255.0
- Specify the gateway through which the system sends the
core dump file to the FTP server. host1(config)#exception gateway 192.168.12.3
- (Optional) Set a username and password for FTP access
to the server where you want to transfer the core dump file. The default
settings are the username anonymous and no password. You can specify
the number 8 before the username and before the password to encrypt
these values. By default, the username and password are not encrypted.host1(config)#exception protocol ftp username userpassword
- (Optional) View parameters associated with creating a
core dump file. You can reload the system software (.rel) file and
the configuration (.cnf) file.host1(config)#reload
Note: Reloading the standby SRP causes high availability to be temporarily disabled until the standby SRP reloads and resynchronizes with the active SRP.
