Help us improve your experience.

Let us know what you think.

Do you have time for a two-minute survey?

Navigation
Guide That Contains This Content
[+] Expand All
[-] Collapse All

    ipv6 pim rp-candidate

    Syntax

    ipv6 pim rp-candidate interfaceType interfaceSpecifier [ group-list accessListName ]
    [ hold-time holdTime ] [ priority priority ] [ interval interval ]

    no ipv6 pim rp-candidate interfaceType interfaceSpecifier
    [ group-list accessListName ]

    Release Information

    Command introduced before JunosE Release 7.1.0.

    Description

    Defines a router as a rendezvous point (RP) router candidate. The no version stops the router from being an RP candidate.

    Options

    • interfaceType—Interface type; see Interface Types and Specifiers
    • interfaceSpecifier—Particular interface; format varies according to interface type; see Interface Types and Specifiers. The autoRP announcement messages will contain the IP address for this interface.
    • accessListName—Access-list containing the set of group prefixes supported by this C-RP. If no group-list is specified, the default value is the entire multicast address range.

      Note: You should not configure negative (that is, deny) access-list entries. BSR has no mechanism for distributing negative entries.

    • holdTime—Amount of time in the range 1–65535 seconds that the BSR keeps an RP in its C-RP list if the BSR does not receive a C-RP advertisement message; default value is 150 seconds
    • priority—Priority field value in the range 0– 255 that the C-RP sends to the BSR in C-RP advertisement messages; default value is 192. In the RP election process, the RP with the lower priority value is preferred.
    • interval—Interval in the range 1–65535 seconds at which the C-RP sends advertisement messages to the BSR; default value is 60 seconds

    Mode

    Global Configuration

    Published: 2014-08-14