Help us improve your experience.

Let us know what you think.

Do you have time for a two-minute survey?

Guide That Contains This Content
[+] Expand All
[-] Collapse All

    ipv6 pim join-prune-interval


    ipv6 pim join-prune-interval interval

    no ipv6 pim join-prune-interval

    Release Information

    Command introduced in JunosE Release 10.0.0.


    Specifies the time interval at which the router sends the PIM join/prune message to the upstream RPF neighbor. In Interface Configuration mode, the no version restores the value that is specified in Router Configuration mode. If the message interval is not specified in Router Configuration mode, then the default value of 60 seconds is restored.

    Note: You cannot configure the designated router priority on PIM dense mode interfaces.


    • interval—Interval in the range 10–210 seconds at which the router sends the PIM join/prune message; the default value is 60 seconds.


    Interface Configuration, Router Configuration

    Published: 2014-08-14