Help us improve your experience.

Let us know what you think.

Do you have time for a two-minute survey?

Guide That Contains This Content
[+] Expand All
[-] Collapse All



    duplex duplexMode

    no duplex

    Release Information

    Command introduced before JunosE Release 7.1.0.


    Specifies the duplex mode for an Ethernet interface. This command works with the speed command; if you set or accept the automatically negotiate setting for either duplex mode or speed, the router negotiates both parameters with the remote device. The no version specifies the default value, automatically negotiate or full duplex (FE-8 SFP I/O module only). This command is not available for the Ethernet interface on the SRP module.


    • duplexMode—One of the following duplex options
      • automatically negotiate—Specifies that the router negotiates duplex mode with the remote device; not valid for the FE-8 SFP I/O module
      • full—Specifies that the router uses full duplex on a Fast Ethernet or Gigabit Ethernet interface
      • half—Specifies that the router uses half duplex on a Fast Ethernet interface; this value is not valid for Gigabit Ethernet interfaces


    Interface Configuration

    Published: 2014-08-14