Help us improve your experience.

Let us know what you think.

Do you have time for a two-minute survey?

Navigation
Guide That Contains This Content
[+] Expand All
[-] Collapse All

    atm oam

    Syntax

    atm oam [ vpi ] [ [ seg-loopback | end-loopback [ loopback-timer time ] ]
    [ cc { source | sink | both } ] ]

    no atm oam [ vpi ] [ [ seg-loopback | end-loopback [ loopback-timer time ] ] ]

    Release Information

    Command introduced before JunosE Release 7.1.0.

    Description

    Configures F4 OAM on an interface or circuit. The no version deletes F4 OAM circuits.

    Note: If you do not specify any options, both F4 end-to-end OAM and F4 segment OAM are enabled on all VPIs on the interface.

    Options

    • vpi—VPI on which you want to enable F4 OAM. If you do not specify a VPI, F4 OAM flow is enabled on all VPIs on the interface.
    • seg-loopback—Enables F4 segment OAM
    • end-loopback—Enables F4 end-to-end OAM
    • loopback-timer—To generate F4 loopback cells on the VPI, you must configure the loopback timer; you can set the loopback timer only for end-to-end loopback
    • time—Time interval in the range 1–600 seconds between transmissions of F4 loopback cells.
    • cc—Enables CC cells on the PVC; you can enable CC cells only on data circuits, not on control circuits, such as ILMI or signaling circuits
    • sink—Enables this VC as a sink point (cell receiver)
    • source—Enables this VC as the source point (cell generator)
    • both—Enables this VC as both a sink point and a source point

    Mode

    Interface Configuration, Subinterface Configuration

    Published: 2014-08-14