Help us improve your experience.

Let us know what you think.

Do you have time for a two-minute survey?

Navigation
Guide That Contains This Content
[+] Expand All
[-] Collapse All

    Example: Configuring a Default Route to a Shared Interface

    For the first solution you create a default route in the VRF that points to a shared IP interface. You must manually create the shared IP interface on top of the layer 2 interface that points to the Internet gateway. See Figure 1.

    The main disadvantage of this approach is that if multiple Internet gateways are available, BGP cannot select the egress gateway that is optimal for each destination prefix. Because BGP has only a default route in the VRF, it has to point that single default route to a single uplink interface. All the Internet-bound traffic must flow out of that interface.

    You cannot configure traffic for one prefix to flow out of one uplink interface and traffic to another prefix to flow out of another uplink interface. That behavior requires a full default-free Internet routing table in the VRF, which is a complication that you want to avoid.

    Figure 1: Static Default Route for Internet Access

    Static Default Route for Internet Access

    The following commands illustrate how to create a shared IP interface in the VRF and point a default route to it:

    host1(config)#virtual-router pe1:pe11 host1:pe1:pe11(config)#interface ip internet-access host1:pe1:pe11(config-if)#ip share-interface atm2/1.3 host1:pe1:pe11(config-if)#ip address 10.1.1.3 255.255.255.255 host1:pe1:pe11(config-if)#exit host1:pe1:pe11(config)#ip route 0.0.0.0 0.0.0.0 ip internet-access

    See Shared IP Interfaces in the JunosE IP, IPv6, and IGP Configuration Guide, for information about shared IP interfaces and default routes.

    Published: 2014-08-18