Help us improve your experience.

Let us know what you think.

Do you have time for a two-minute survey?

Guide That Contains This Content
[+] Expand All
[-] Collapse All

    BFD Protocol for PIM for IPv6 Overview

    The ipv6 pim bfd-liveness-detection command configures the Bidirectional Forwarding Detection (BFD) protocol for PIM. The BFD protocol uses control packets and shorter detection time limits to more rapidly detect failures in a network. Also, because they are adjustable, you can modify the BFD timers for more or less aggressive failure detection.

    PIM routers send periodic hello messages from each PIM-enabled interface. You can configure this interval using the ipv6 pim query-interval command. By default, the PIM router sends a hello message every 30 seconds (with an interval range of 0–210 seconds). If it receives no response from a neighbor within 3.5 times the interval value (a minimum of 3.5 seconds), the PIM router drops the neighbor.

    In contrast, when a BFD session exists between neighbors, a PIM neighbor that goes down is detected quickly (in milliseconds rather than in seconds).

    When you issue the ipv6 pim bfd-liveness-detection command on a PIM router, the router establishes BFD liveness detection with all BFD-enabled PIM neighbors. When the local router receives an update from a remote PIM neighbor—if BFD is enabled and if the session is not already present—the local router attempts to create a BFD session to the remote neighbor.

    Each adjacent pair of neighbors negotiates an acceptable transmit interval for BFD packets. The negotiated value can be different on each neighbor. Each neighbor then calculates a BFD liveness detection interval. When a neighbor does not receive a BFD packet within the detection interval, it declares the BFD session to be down.

    Note: Before the router can use the ipv6 pim bfd-liveness-detection command, you must specify a BFD license key. To view an already configured license, use the show license bfd command.

    For general information about configuring and monitoring the BFD protocol, see Configuring BFD in the JunosE IP Services Configuration Guide.

    Published: 2014-08-19