Help us improve your experience.

Let us know what you think.

Do you have time for a two-minute survey?

Navigation
Guide That Contains This Content
[+] Expand All
[-] Collapse All

    Local Cross-Connects Between Layer 2 Interfaces Using MPLS Overview

    You can configure layer 2 services over MPLS to transmit data between two layer 2 interfaces that reside on the same E Series router. In this configuration, which is referred to as a local cross-connect, traffic that arrives at the router’s ingress interface is switched out the egress interface, instead of going through an MPLS core network.

    A local cross-connect enables the router to function as a layer 2 switch. It operates with any supported layer 2 service. To configure local cross-connects, you must use the mpls-relay command.

    Published: 2014-08-18