interface gigabitEthernet

Syntax

[ no ] interface gigabitEthernet interfaceSpecifier

Release Information

Command introduced before JunosE Release 7.1.0.

Description

Specifies or creates a Gigabit Ethernet interface or a subinterface over a Gigabit Ethernet interface. The no version removes the interface or subinterface. You must issue the no version from the highest level down; you cannot remove an interface or subinterface if the one above it still exists.

Note: On the GE I/O module, you can configure only the primary port, 0. The router automatically uses the redundant port, 0R, if the primary port fails.

On the GE-2 APS I/O module, you can configure only the primary ports, 0 and 1. The router automatically uses the corresponding redundant port, 0R or 1R, if the primary port fails.

On the OC3-2 GE APS I/O module, you can configure only a Gigabit Ethernet interface in port 2. Ports 0 and 1 are reserved for OC3/STM1 ATM interfaces.

On the ES-2 GE-4 IOA, you can configure all four ports.

Options

Mode

Global Configuration

Related Documentation