Configuring IPv4 and IPv6 Interface Columns over Static and Dynamic PPPoE

You can configure IPv4 and IPv6 interface columns over static and dynamic PPPoE, as shown in Figure 54.

Figure 54: IPv4 and IPv6 Interface Columns over Static and Dynamic PPPoE

To configure IPv4 and IPv6 interface columns over dynamic PPPoE:

1. Specify the loopback mode for an interface and assign both IPv6 and IPv4 addresses to the interface.
   host1(config)#interface loopback 1host1(config-if)#ipv6 address 2000::1/64host1(config-if)#ip address 2.2.2.1/24
2. Create a profile that defines attributes for the dynamic interface. You can use this profile to configure IPv4 or IPv6, or both IPv4 and IPv6 PPP interfaces.
   host1(config)#profile ipv4Ipv6Profilehost1(config-profile)#ip virtual-router ppphost1(config-profile)#ip unnumbered loopback 1host1(config-profile)#ipv6 virtual-router ppphost1(config-profile)#ipv6 unnumbered loopback 1host1(config-profile)#ipv6 nd other-config-flaghost1(config-profile)#ipv6 nd ra-interval 10host1(config-profile)#ppp authentication chaphost1(config-profile)#exit
3. Specify the interface.
   host1(config-if)#interface gigabitEthernet 4/0/6
4. Set the encapsulation type to PPPoE.
   host1(config-subif)#pppoe
5. Configure the interface to detect and accept dynamic PPPoE subinterfaces.
   host1(config-subif)#pppoe auto-configure
6. Assign the profile to any autoconfigured encapsulation.
   host1(config-if)#pppoe profile any ipv4Ipv6Profile

Related Documentation

• Configuring IPv4 Characteristics for a Profile
• Configuring IPv6 Characteristics for a Profile
• Configuring MLPPP and PPP Characteristics for a Profile
• Monitoring Total Static and Dynamic Interface Counts for Interface Columns
• interface gigabitEthernet
• interface loopback
• ip address
• ip unnumbered
• ip virtual-router
• ipv6 address
• ipv6 nd other-config-flag
• ipv6 nd ra-interval
• ipv6 unnumbered
• ipv6 virtual-router
• ppp authentication
• pppoe
• pppoe auto-configure
• pppoe profile
• profile