Configuring Fragmentation and Reassembly for Dynamic MLPPP

To configure fragmentation and reassembly for dynamic MLPPP, you must create a profile that includes commands to define the link and bundle attributes, just as you do for a static MLPPP configuration.

For more information, see:

To define a profile that configures MLPPP fragmentation and reassembly for a dynamic MLPPP interface:

From Global Configuration mode, create a profile by assigning it a name, and access Profile Configuration mode.
host1(config)#profile dynmlppp1 host1(config-profile)#
Enable the creation of dynamic MLPPP interfaces.
host1(config-profile)#ppp multilink enable

Enable fragmentation on the link interface, and optionally specify the maximum allowable fragment size to use.

host1(config-profile)#ppp fragmentation 128

Note: You can specify the maximum fragment size for a link only when you use the ppp fragmentation command to enable fragmentation on that link. You cannot specify the maximum fragment size for a link when fragmentation is disabled.

Enable reassembly on the link interface, and optionally specify the administrative MRRU value to use.

host1(config-profile)#ppp reassembly 1800

Note: You can specify the administrative MRRU value for a link only when you use the ppp reassembly command to enable reassembly on that link. You cannot specify the administrative MRRU for a link when reassembly is disabled.

(Optional) Specify a virtual router to which dynamic IP interfaces created with this profile will be assigned.
host1(config-profile)#ip virtual-router boston
(Optional) Specify an IP loopback interface with which dynamic IP interfaces created with this profile will be associated.
host1(config-profile)#ip unnumbered loopback 0
(Optional) Set other PPP characteristics as needed by using the ppp commands. For more information about the ppp commands, see JunosE Command Reference Guide.

Configuring Fragmentation and Reassembly for Dynamic MLPPP

Related Documentation