Configuring a Destination Profile for Dynamic DVMRP Tunnels

To configure a destination profile for dynamic DVMRP tunnels:

  1. Configure a destination profile for DVMRP.

    host1(config-dest-profile)#dvmrp destination profile kanata1 virtual-router vr1

  2. Set the source address for the tunnel.
    host1(config-dest-profile)#tunnel source 1.1.1.1
  3. Set the destination address for the tunnel.
    host1(config-dest-profile)#tunnel destination subnet 10.0.0.0 255.0.0.0
  4. (Optional) Set the maximum transmission unit (MTU) size for the tunnel.
    host1(config-dest-profile)#tunnel mtu 10240
  5. (Optional) Configure an IP profile with parameters that are used to stack an upper IP interface over a dynamic DVMRP tunnel.
    host1(config-dest-profile)#profile ip-kanata
  6. (Optional) Enable IPsec transport mode.
    host1(config-dest-profile)#enable ipsec-transport
  7. (Optional) Create a multicast VPN tunnel.
    host1(config-dest-profile)#tunnel mdt profile kanata-mdt

Related Documentation