Configuring OSPF Traps

You can use the traps command to specify OSPF traps. This command enables you to specify all or any number of the following trap settings:

virtIfStateChange—To indicate any state change on an OSPF virtual interface
nbrStateChange—To indicate any state change on a nonvirtual OSPF neighbor
virtNbrStateChange—To indicate any state change on a virtual OSPF neighbor
ifConfigError—To indicate any configuration mismatch with a nonvirtual neighbor
virtIfConfigError—To indicate any configuration mismatch with a virtual neighbor
ifAuthFailure—To indicate any authentication failure on a nonvirtual interface
virtIfAuthFailure—To indicate any authentication failure on a virtual interface
ifRxBadPkt—To indicate the receipt of a packet that the router cannot parse
virtIfRxBadPkt—To indicate the receipt of a packet on a virtual interface that the router cannot parse
txRetransmit—To indicate the retransmittal of a packet on a nonvirtual interface
virtTxRetransmit—To indicate the retransmittal of a packet on a virtual interface
originateLsa—To indicate the origination of a new LSA by this router
maxAgeLsa—To indicate that an LSA in this router LSDB has reached its maximum age value
ifStateChange—To indicate a state change on an OSPF interface

traps