JunosE 15.1.0 Release Notes

Resolved Known Problems

Release 15.1.0 is based on Release 14.3.0 and incorporates all problem resolutions found in that release. The following problems were reported open in Release 14.3.0 and have been resolved in this release, or have been resolved since the 14.3.0 release. For more information about problems in this list that were reported by customers, you can log in to the JunosE Knowledge Base at https://www2.juniper.net/kb/, enter the defect ID number in the Search by Keyword field, and click Search. Problems that have not been reported by customers are documented only in these Release Notes.

MPLS

• In a scaled environment with a large number of MPLS RSVP-TE tunnels configured, the states of the hello adjacency instances in the State field in the output of the show mpls rsvp hello instance command are displayed as Down for loopback interfaces. The correct behavior is that the RSVP-TE hello adjacencies must always be in the Up state for loopback interfaces. [Defect ID 189565]

Policy Management

• On the E120 and E320 routers, when a mirror rule is deleted after a COA request is sent with Juniper-LI-Action set to No-Action, the existing mirroring session is not disabled. [Defect ID 84826]

Service Manager

• When show service-management subscriber-session subscriberName interface interfaceType interfaceSpecifier or show service-management subscriber-session subscriberName interface interfaceType interfaceSpecifier service-session serviceName command is issued on the default virtual router or any other virtual router after activating an independent IPv6 service, no output is displayed in the CLI interface except the one on which the subscriber session is active. [Defect ID 181929]