Setting a Two-Rate Rate-Limit-Profile

You can use the rate-limit-profile two-rate command to create a rate-limit profile and enter Rate Limit Profile Configuration mode, from which you can configure attributes for the rate-limit profile. See the Policy Action Applied Based on Rate Settings and Traffic Rate table in Two-Rate Rate-Limits Overview.

Note: The JunosE Software includes the layer 2 headers in the calculations it uses to enforce the rates that you specify in rate-limit profiles.

Use one of the ip, ipv6, l2tp, or mpls keywords in front of the command to specify the type of rate-limit profile you want to create or modify. If you do not include one of the keywords, the router creates an IP rate-limit profile by default.

For hierarchical rate limits, do not specify the interface type, but add the hierarchical keyword at the end. In Parent Group Configuration Mode, associates a rate limit for a parent group. The color-aware keyword is only supported on hierarchical rate limits.

If you do not include a one-rate or two-rate keyword, the default is a two-rate rate-limit profile. If you enter a rate-limit-profile command and then type exit, the router creates a rate-limit profile with the default values listed in Table 15:

Table 15: Two-Rate Rate-Limit-Profile Defaults

Policy Attribute

Default Value

type

two-rate

committed-rate

0

committed-burst

8192

peak-rate

0

peak-burst

8192

committed-action

transmit

conformed-action

transmit

exceeded-action

drop

mask (IP and IPv6 rate-limit profiles)

255

exp-mask (MPLS rate-limit profiles)

7

During a software upgrade, certain values are set as follows:

Related Documentation