path ds3 mdl string

Syntax

path pathChannel ds3 ds3Channel mdl string { eic eicValue | fic ficValue |
generator genValue | lic licValue | pfi pfiCode | port portValue | unit unitValue }

no path pathChannel ds3 ds3Channel mdl string { eic | fic | generator | lic | pfi |
port | unit }

Release Information

Command introduced before JunosE Release 7.1.0.

Description

Allows you to configure an MDL message on a DS3 signal as defined in the ANSI T1.107a-1990 specification. This command applies to a DS3 over channelized SONET interface. The no version restores the default value to the specified MDL message or to all MDL messages.

Options

pathChannel—Number, in the range 1–2147483648, that identifies the path
ds3Channel—Number, in the range 1–3, that identifies the path
eicValue—Equipment identification code; 1–10 characters; default value is the null value
ficValue—Frame identification code; 1–10 characters; default value is the null value
genValue—Generator number to send in the MDL test signal message; 1–38 characters; default value is the null value
licValue—Line identification code; 1–11 characters; default value is the null value
pfiCode—Facility identification code to send in the MDL path message; 1–38 characters; default value is the null value
portValue—Equipment port number to send in the MDL idle signal message; 1–38 characters; default value is the null value
unitValue—Unit identification code; 1–6 characters; default value is the null value

Mode

Controller Configuration