mpls l2transport load-balancing-group

Syntax

mpls l2transport load-balancing-group groupNumber
[ mpls-relay remoteIpAddress | route interface tunnel lspName ]
[ vc-id ] vcIdValue [ group-id groupIdValue ]
[ control-word | no-control-word ] [ sequencing | no-sequencing ]
[ relay-format { ethernet | ppp | vlan } ]

no mpls l2transport load-balancing-group groupNumber
{ mpls-relay remoteIpAddress | route interface tunnel lspName } [ vc-id ] vcId

Release Information

Command introduced before JunosE Release 7.1.0.
control-word, no-control-word, sequencing, and no-sequencing keywords added in JunosE Release 7.1.0.

Description

Specifies a Martini layer 2 transport circuit, associates it with a load-balancing group, and accesses L2 Transport Load-Balancing-Circuit Configuration mode. The no version removes a circuit from the load-balancing group and all subinterfaces that the circuit was configured on.

Note: Using the mpls-relay keywords has the same effect as using the mpls-relay command. Using the route interface keywords has the same effect as using the route interface commands. The relay-format frame-relay option is not supported for the mpls l2transport load-balancing-group command.

Options

Mode

Global Configuration

Related Documentation