bridge vpls rd

Syntax

bridge vplsName vpls rd routeDistinguisher

no bridge vplsName vpls rd

Release Information

Command introduced in JunosE Release 7.1.0.

Description

Specifies the unique two-part route distinguisher for a VPLS instance that uses BGP as the signaling protocol. Because you cannot change or remove the route distinguisher for a VPLS instance after you set it, issuing the no version fails, and causes the router to display an error message.

The following rules apply when you configure the route distinguisher for a VPLS instance:

The bridge vpls rd command is not valid for a VPLS instance that uses LDP as the signaling protocol. To configure a VPLS instance with LDP signaling, use the mpls ldp vpls vpls-id command and the mpls ldp vpls neighbor command.

Note: The bridge vpls rd command is available for a VPLS instance only after you issue the bridge vpls transport-virtual-router command, which creates the VPLS instance and configures the transport virtual router.

Options

Mode

Global Configuration

Related Documentation