atm pvc

Syntax

To create a PVC on an ATM interface when using the aal5snap, aal5autoconfig, or aal5mux ip encapsulation type:

atm pvc vcd vpi vci encapsulation [ cbr cbr | peak [ average burst [ rt ] ] ]
[ oam [ seconds | cc [ segment | end-to-end ] { source | sink | both } ] ]
[ inArp [ minutes ] ]

no atm pvc vcd

To create a PVC on an ATM interface when using the aal5all, aal0, or ilmi encapsulation type:

atm pvc vcd vpi vci encapsulation [ cbr cbr | peak [ average burst [ rt ] ] ]

no atm pvc vcd

To use a profile to apply encapsulation and traffic-shaping parameters to a bulk range of PVCs configured for a dynamic ATM 1483 subinterface:

atm pvc encapsulation [ cbr cbr | peak [ average burst [ rt ] ] ] [oam seconds ]

no atm pvc

Release Information

Command introduced before JunosE Release 7.1.0.

Description

From Interface Configuration or Subinterface Configuration mode, creates a PVC on an ATM interface. The no version removes the specified PVC.

From Profile Configuration mode, applies encapsulation, traffic-shaping, and OAM parameters to the range of PVCs configured on a static ATM AAL5 interface for use by a dynamic ATM 1483 subinterface. The no version restores the default service type, UBR, on the VC range.

Note: The optional peak, average, and burst parameters configure traffic-shaping parameters for the circuit. The allowable traffic-shaping features and range specifications depend on the line module capabilities.

Options

Mode

Interface Configuration, Profile Configuration, Subinterface Configuration

Related Documentation