[ Contents] [ Prev] [ Next] [ Index] [ Report an Error]

test interface inband-line-loop

Syntax


            
               test interface inband-line-loop (ansi  (initiate | terminate)
                  | bellcore (initiate | terminate)
               
               t1-fpc/pic/port<:channel>

Release Information

Command introduced before JUNOS Release 7.4.

Description

Send commands on a T1 interface to initiate or terminate a far-end line loopback using either an ANSI or Bellcore FDL command code. If the far end of the connection is in C-bit parity mode and it has been configured to accept line loopback requests from the near end, the far end executes the request.

Note: The following restrictions apply to this command:

On Channelized DS3-to-DS1 and Multichannel DS3 PICs, this command can only be initiated by T1 interfaces. These types of T1 interfaces cannot accept a request for this test sent by another router.
This command is not supported on the 4-port T1 PIC.

Options

ansi — ANSI FDL command code.

bellcore — Bellcore FDL command code.

initiate — Initiate the far-end payload loopback.

terminate — Terminate the far-end payload loopback.

t1-fpc/pic/port<:channel> — Name of a T1 interface. The channel number indicates a channelized interface.

Required Privilege Level

view

List of Sample Output

test interface inband-line-loop

Output Fields

To display the state and the number of times the interface has placed itself into remote loopback, use the show interfaces extensive command.

Sample Output

test interface inband-line-loop

user@host> test interface inband-line-loop ansi
               initiate t1-1/0/0

[ Contents] [ Prev] [ Next] [ Index] [ Report an Error]