show chassis power-ratings

Device

Physical Interface Module (PIM) slot. (PIM slot numbers appear as FPC numbers in the output.)

Total Tokens

Maximum number of low-power, high-power, and heat tokens available for the router:

• Low Power—Maximum number of low-power consumption tokens available for the router.
• High Power—Maximum number of high-power consumption tokens available for the router.
• Heat—Maximum number of heat tokens available for the router.

FPC number

PIM slot number and power and heat information for the PIM in this slot:

• Low Power—PIM low-power consumption. The number of low-power tokens used by the PIM.
• High Power—PIM high-power consumption. The number of high-power tokens used by the PIM.
• Heat—The number of PIM heat dissipation tokens used by this PIM.
• Ratings—Status of the PIM slot. The status of the slot is based on either the configuration of the slot or the power use and heat dissipation of the PIM in that slot:

  Note: The request chassis fpc command has no effect on the status of the PIM slot.

  • OK—The PIM in this PIM slot can be brought online.
  • Exceeded—The PIM cannot be brought online because the PIM slot has been disabled by J Series power management. The PIM in this PIM slot exceeds the maximum number of low-power tokens, high-power tokens, or heat tokens.
  • Empty—No PIM is installed in the PIM slot.
  • Cfg offline—The PIM cannot be brought online because the PIM slot has been disabled by the set chassis fpc offline command.

Tokens Used

Total number of low-power, high-power, and heat tokens used by the router:

• Low Power—The total number of low-power tokens used by the router.
• High Power—The total number of high-power tokens used by the router.
• Heat—Number of heat tokens used by the router.
• Ratings—If blank, J Series power management is enabled. No Power Mgmt indicates that J Series power management has been disabled by the set chassis disable_power_management command.

  Note: Use extreme caution when disabling J Series power management. To prevent equipment damage, do not install a combination of PIMs that exceeds the power and heat capacity of the router when J Series power management is disabled.