Layer 2 Tunneling Protocol Operational Mode Commands

[ Contents] [ Prev] [ Next] [ Index] [ Report an Error]

Table 246 summarizes the command-line interface (CLI) commands you can use to monitor and troubleshoot Layer 2 Tunneling Protocol (L2TP) services. Commands are listed in alphabetical order.

Table 246: L2TP Services Operational Mode Commands

Task	Command
Clear L2TP multilink bundles.	clear services l2tp multilink
Clear L2TP sessions.	clear services l2tp session
Clear L2TP tunnels.	clear services l2tp tunnel statistics
Display L2TP multilink bundles.	show services l2tp multilink
Display RADIUS server and statistics information.	show services l2tp radius
Display active L2TP sessions.	show services l2tp session
Display L2TP summary information.	show services l2tp summary
Display active L2TP tunnels.	show services l2tp tunnel
Display active L2TP users.	show services l2tp user

Note: L2TP services are supported on the adaptive services (sp-fpc/pic/port) interface on M7i and M10i routers.

Note: For information about how to configure L2TP services, see the JUNOS Services Interfaces Configuration Guide.

[ Contents] [ Prev] [ Next] [ Index] [ Report an Error]