Navigation
Table of Contents
Guide That Contains This Content
[+] Expand All
[-] Collapse All
Related Documentation
- ACX Series
- RIP Overview
- Example: Configuring a Basic RIP Network
- J Series
- RIP Overview
- Example: Configuring a Basic RIP Network
- M Series
- RIP Overview
- Example: Configuring a Basic RIP Network
- MX Series
- RIP Overview
- Example: Configuring a Basic RIP Network
- QFX Series
- RIP Overview
- Example: Configuring a Basic RIP Network
- SRX Series
- RIP Overview
- Example: Configuring a Basic RIP Network
- T Series
- RIP Overview
- Example: Configuring a Basic RIP Network
Understanding Basic RIP Routing
RIP is an interior gateway protocol (IGP) that routes packets within a single autonomous system (AS). By default, RIP does not advertise the subnets that are directly connected through the device's interfaces. For traffic to pass through a RIP network, you must create a routing policy to export these routes. Advertising only the direct routes propagates the routes to the immediately adjacent RIP-enabled router only. To propagate all routes through the entire RIP network, you must configure the routing policy to export the routes learned through RIP.
Related Documentation
- ACX Series
- RIP Overview
- Example: Configuring a Basic RIP Network
- J Series
- RIP Overview
- Example: Configuring a Basic RIP Network
- M Series
- RIP Overview
- Example: Configuring a Basic RIP Network
- MX Series
- RIP Overview
- Example: Configuring a Basic RIP Network
- QFX Series
- RIP Overview
- Example: Configuring a Basic RIP Network
- SRX Series
- RIP Overview
- Example: Configuring a Basic RIP Network
- T Series
- RIP Overview
- Example: Configuring a Basic RIP Network
