TechLibrary

Table of Contents

Guide That Contains This Content

[+] Expand All

[-] Collapse All

Locate Loss of Pointer Path Alarms

Problem

A loss of pointer path (LOP-P) alarm indicates a possible provisioning problem and occurs when the Juniper Networks router cannot determine a valid payload pointer. The Juniper Networks router monitors the H1/H2 bytes, located in the line overhead area. This alarm is usually discovered upon initial provisioning of SONET circuits, and is not generally seen after the router has been deployed in the network for some time.

Solution

To display SONET alarms and errors, use the following Junos OS CLI operational mode command:

user@host> show interfaces so-fpc/pic/port extensive

Sample Output

user@host> show interfaces so-1/1/1 extensive

[...Output truncated...]
SONET alarms   : LOP
  SONET defects  : LOP
  SONET PHY:            Seconds        Count  State
    PLL Lock                  0            0  OK
    PHY Light                 0            0  OK
  SONET section:
    BIP-B1                    0            0
    SEF                       0            0  OK
    LOS                       0            0  OK
    LOF                       0            0  OK
    ES-S                      0
    SES-S                     0
    SEFS-S                    0
  SONET line:
    BIP-B2                    0            0
    REI-L                     0            0
    RDI-L                     0            0  OK
    AIS-L                     0            0  OK
    BERR-SF                   0            0  OK
    BERR-SD                   0            0  OK
    ES-L                      0
    SES-L                     0
    UAS-L                     0
    ES-LFE                    0
    SES-LFE                   0
    UAS-LFE                   0
  SONET path:
    BIP-B3                    0            0
    REI-P                     0            0
    LOP-P                   174            0  Defect Active
    AIS-P                     0            0  OK
    RDI-P                     0            0  OK
    UNEQ-P                    0            0  OK
    PLM-P                     0            0  OK
     ES-P                    174
    SES-P                   174
    UAS-P                   174
    ES-PFE                    0
    SES-PFE                   0
    UAS-PFE                   0
[...Output truncated...]

Meaning

The sample output shows that an LOP-P alarm occurred for 174 seconds. An LOP-P alarm can occur when the ADM on the other end is configured for nonconcatenate mode, while the Juniper Networks router is configured for concatenate mode (the default setting). In this instance, the pointer word in the required STS frame does not have the concatenation indicator set.

The condition of 8, 9, or 10 consecutive frames without valid pointer values can raise an LOP-P alarm.

Note: Although Juniper routers do not report pointer adjustments, an LOP-P alarm will not occur as long as the pointer adjustments stay within tolerance levels.

TechLibrary

Related Documentation

Locate Loss of Pointer Path Alarms

Problem

Solution

Related Documentation

Published: 2012-06-29