Related Documentation
- ACX Series
- Ethernet OAM Connectivity Fault Management
- Example: Configuring Ethernet CFM over VPLS
- MX Series
- Ethernet Operations, Administration, and Maintenance
- Ethernet OAM Connectivity Fault Management
- Example: Configuring Ethernet CFM over VPLS
- Example: Configuring Ethernet CFM on Bridge Connections
- Additional Information
- Ethernet OAM
Example: Configuring Ethernet CFM on Physical Interfaces
CFM can be used to monitor the physical link between two routers. This functionality is similar to that supported by the IEEE 802.3ah LFM protocol.
In Junos OS Release 9.3 and later, CFM also supports aggregated Ethernet interfaces. On interfaces configured on Modular Port Concentrators (MPCs) and Modular Interface Cards (MICs) on MX Series routers, CFM is not supported on untagged aggregated Ethernet member links. MPCs and MICs do support CFM on untagged and tagged aggregated Ethernet logical interfaces.
 | Note: The configurations in this example are only partial examples of complete and functional router configurations. Do not copy these configurations and use them directly on an actual system. |
In the following example, two routers (Router 1 and Router 2) are connected by a point-to-point Gigabit Ethernet link. The link between these two routers is monitored using CFM. This is shown in Figure 1. The single boundary is a “down mep” in CFM terminology.
Figure 1: Ethernet CFM on Physical Interfaces
Router 1
Configure the interface and CFM:
The configuration on Router 2 mirrors that on Router 1, with the exception of the mep-id.
Router 2
Configure the interface and CFM:
Related Documentation
- ACX Series
- Ethernet OAM Connectivity Fault Management
- Example: Configuring Ethernet CFM over VPLS
- MX Series
- Ethernet Operations, Administration, and Maintenance
- Ethernet OAM Connectivity Fault Management
- Example: Configuring Ethernet CFM over VPLS
- Example: Configuring Ethernet CFM on Bridge Connections
- Additional Information
- Ethernet OAM
