TechLibrary

Table of Contents

Guide That Contains This Content

[+] Expand All

[-] Collapse All

Example: Configuring the Number of Redundant Ethernet Interfaces in a Chassis Cluster

This example shows how to specify the number of redundant Ethernet interfaces for a chassis cluster. You must configure the redundant Ethernet interfaces count so that the redundant Ethernet interfaces that you configure are recognized.

Requirements

Before you begin, set the chassis cluster ID and chassis cluster node ID. See Example: Setting the Chassis Cluster Node ID and Cluster ID.

Overview

Before you configure redundant Ethernet interfaces for a chassis cluster, you must specify the number of redundant Ethernet interfaces for the chassis cluster.

In this example, you set the number of redundant Ethernet interfaces for a chassis cluster to 2.

Configuration

Step-by-Step Procedure

To set the number of redundant Ethernet interfaces for a chassis cluster:

Specify the number of redundant Ethernet interfaces:
{primary:node0}[edit]user@host# set chassis cluster reth-count 2
If you are done configuring the device, commit the configuration.
[edit]user@host# commit

Verification

To verify the configuration is working properly, enter the show configuration chassis cluster command.