Navigation
Table of Contents
Guide That Contains This Content
[+] Expand All
[-] Collapse All
Related Documentation
- M Series
- Understanding IGMP
- MX Series
- Understanding IGMP
- SRX Series
- Understanding IGMP
- T Series
- Understanding IGMP
Accepting IGMP Messages from Remote Subnetworks
By default, IGMP interfaces accept IGMP messages only from the same subnet. Including the promiscuous-mode statement enables the routing device to accept IGMP messages from indirectly connected subnets.
 | Note: When you enable IGMP on an unnumbered Ethernet interface that uses a /32 loopback address as a donor address, you must configure IGMP promiscuous mode to accept the IGMP packets received on this interface. |
To enable IGMP promiscuous mode on an interface:
- Configure the IGMP interface.[edit protocols igmp]user@host# set interface ge-0/1/1.0 promiscuous-mode
- Verify the configuration by checking the Promiscuous Mode field in the output of the show igmp interface command.
- Verify the operation of the filter by checking the Rx non-local field in the output of the show igmp statistics command.
Related Documentation
- M Series
- Understanding IGMP
- MX Series
- Understanding IGMP
- SRX Series
- Understanding IGMP
- T Series
- Understanding IGMP
