Monitoring RIP Routing Information
This topic applies only to the J-Web Application package.
Use the monitoring functionality to monitor RIP routing on routing devices.
To view RIP routing information in the J-Web interface, select Monitor > Routing > RIP Information.
To view RIP routing information in the CLI, enter the following CLI commands:
show rip statistics
show rip neighbor
Table 1 summarizes key output fields in the RIP routing display in the J-Web interface.
Table 1: Summary of Key RIP Routing Output Fields
The RIP protocol name.
The port on which RIP is enabled.
Hold down time
The interval during which routes are neither advertised nor updated.
Global routes learned
Number of RIP routes learned on the logical interface.
Global routes held down
Number of RIP routes that are not advertised or updated during the hold-down interval.
Global request dropped
Number of requests dropped.
Global responses dropped
Number of responses dropped.
Name of the RIP neighbor.
This value is the name of the interface on which RIP is enabled. Click the name to see the details for this neighbor.
State of the RIP connection: Up or Dn (Down).
Local source address.
This value is the configured address of the interface on which RIP is enabled.
This value is the configured address of the immediate RIP adjacency.
The mode of sending RIP messages.
The mode in which messages are received.
Value of the incoming metric configured for the RIP neighbor.