Help us improve your experience.

Let us know what you think.

Do you have time for a two-minute survey?

 

Setting an Uplink Port as a Virtual Chassis Port Using the LCD Panel

 

This topic describes how to set or delete the uplink ports as VCPs using the LCD panel.

The following procedure shows how to configure uplink module port ge-0/1/2 as a VCP.

To set an uplink port as a VCP using the LCD panel:

  1. Press Menu until you see MAINTENANCE MENU.
  2. Press Menu until you see REQUEST VC PORT.
  3. Press Enter. You will see SET VC PORT?.
  4. Press Enter. You will see SET FPC 0?.
  5. Press Enter. You will see SET PIC 0?.
  6. Press Menu until you see SET PIC 1?.
  7. Press Enter. You will see SET PORT 0?.
  8. Press Menu until you see SET PORT 2?.
  9. Press Enter. You will see CONFIGURING ....
  10. Once the configuration has been accepted, press Enter to return to the MAINTENANCE menu.

You can also use the LCD panel to delete a VCP, thus resetting the port to an uplink port.

To reset vcp-0/1/2 to an uplink port using the LCD panel:

  1. Press Menu until you see MAINTENANCE MENU.
  2. Press Menu until you see REQUEST VC PORT.
  3. Press Enter. You will see SET VC PORT?.
  4. Press Menu. You will see DELETE VC PORT?.
  5. Press Enter. You will see DELETE FPC 0?.
  6. Press Enter. You will see DELETE PIC 0?.
  7. Press Menu until you see DELETE PIC 1?.
  8. Press Enter. You will see DELETE PORT 0?.
  9. Press Menu until you see DELETE PORT 2?.
  10. Press Enter. You will see CONFIGURING ....
  11. Once the configuration has been accepted, press Enter to return to the MAINTENANCE menu.