Configuring Static Routing (J-Web Procedure)
You can use the J-Web interface to configure static routes for EX Series switches.
To configure static routes:
- Select Configure > Routing > Static Routing. The Static Routing page displays details of
the configured routes.
After you make changes to the configuration on this page, you must commit the changes for them to take effect. To commit all changes to the active configuration, select Commit Options > Commit. See Using the Commit Options to Commit Configuration Changes for details about all commit options.
Click one of the following options:
Table 1: Static Routing Configuration Summary
Specifies the default gateway for the switch.
Note: IPv6 is not supported on EX2200 and EX4500 switches.
To specify an IPv4 address:
To specify an IPv6 address:
Specifies the next-hop address or addresses to be used when routing traffic to the static route.
To add an address:
To delete a next-hop address, select it from the list and click Delete.