Configuring SNMP (J-Web Procedure)
This topic applies only to the J-Web Application package.
You can use the J-Web interface to define system identification information, create SNMP communities, create SNMP trap groups, and configure health monitor options for EX Series switches.
To configure SNMP features:
- Select Configure > Services > SNMP.
- Enter information into the configuration page for SNMP as described in Table 1.
- To apply the configuration click Apply.
After you make changes to the configuration on this page, you must commit the changes for them to take effect. To commit all changes to the active configuration, select Commit Options > Commit. See Using the Commit Options to Commit Configuration Changes for details about all commit options.
Table 1: SNMP Configuration Page
Free-form text string that specifies an administrative contact for the system.
Type contact information for the administrator of the system (such as name and phone number).
Free-form text string that specifies a description for the system.
Type information that describes the system
Local Engine ID
Provides an administratively unique identifier of an SNMPv3 engine for system identification.
The local engine ID contains a prefix and a suffix. The prefix is formatted according to specifications defined in RFC 3411. The suffix is defined by the local engine ID. Generally, the local engine ID suffix is the MAC address of Ethernet management port 0.
Type the MAC address of Ethernet management port 0.
Free-form text string that specifies the location of the system.
Type location information for the system (lab name or rack name, for example).
System Override Name
Free-form text string that overrides the system hostname.
Type the hostname of the system.
To add a community, click Add
Specifies the name of the SNMP community.
Type the name of the community being added.
Specifies the type of authorization (either read-only or read-write) for the SNMP community being configured.
Select the authorization (either read-only or read-write) from the list.
To add a trap group, click Add.
Trap Group Name
Specifies the name of the SNMP trap group being configured.
Type the name of the group being added.
Specifies which trap categories are added to the trap group being configured.
Specifies one or more hostnames or IP addresses for the systems to receive SNMP traps generated by the trap group being configured.
Enable Health Monitoring
Enables the SNMP health monitor on the switch. The health monitor periodically (over the time you specify in the interval field) checks the following key indicators of switch health:
Select the check box to enable the health monitor and configure options. Clear the check box to disable the health monitor.
Note: If you select the Enable Health Monitoring check box and do not specify options, then SNMP health monitoring is enabled with default values.
Specifies the sampling frequency, in seconds, over which the key health indicators are sampled and compared with the rising and falling thresholds.
For example, if you configure the interval as 100 seconds, the values are checked every 100 seconds.
Enter an interval time, in seconds, from 1 through 2147483647.
The default value is 300 seconds (5 minutes).
Specifies the value at which SNMP generates an event (trap and system log message) when the value of a sampled indicator is increasing.
For example, if the rising threshold is 90 (the default), SNMP generates an event when the value of any key indicator reaches or exceeds 90 percent.
Enter a value from 0 through 100. The default value is 90.
Specifies the value at which SNMP generates an event (trap and system log message) when the value of a sampled indicator is decreasing.
For example, if the falling threshold is 80 (the default), SNMP generates an event when the value of any key indicator falls back to 80 percent or less.
Enter a value from 0 through 100. The default value is 80.
Note: The falling threshold value must be less than the rising threshold value.