Help us improve your experience.

Let us know what you think.

Do you have time for a two-minute survey?

 

Configuring the In-Band Management Interface on NFX350

 

In in-band management, you configure a network interface as a management interface and connect it to the management device. You can configure any of the ge-1/0/x ports, where x ranges from 0 to 4, as in-band management interfaces.

To configure in-band management:

  1. Log in to the JCP CLI and enter configuration mode:
    root@host% cli
    root@host> configure


  2. Configure VLAN tagging:
    root@host# set interfaces ge-1/0/x vlan-tagging
    root@host# set interfaces ge-1/0/x unit n vlan-id mgmt-vlan-id
    root@host# set interfaces ge-1/0/x unit n family inet address address/prefix-length

To configure a LAN port for in-band management:

  1. Configure the management VLAN:
    root@host# set vlans mgmt-vlan vlan-id vlan-id


  2. Add the physical network interface and the service interface as members of the VLAN:
    root@host# set interfaces ge-0/0/x unit 0 family ethernet-switching vlan members mgmt-vlan

    Where x ranges from 0 to 7.

    root@host# set interfaces sxe-0/0/x unit 0 family ethernet-switching vlan members mgmt-vlan

    Where x ranges from 0 to 3.

Note

If the device is in throughput mode, you must map ge-1/0/x to sxe-0/0/x by using the set vmhost virtualization-options interfaces ge-1/0/x mapping interface hsxex command. If the device is in hybrid or compute mode, you can map ge-1/0/x to OVS by using the set vmhost virtualization-options interfaces ge-1/0/x command or map to SR-IOV by using the set vmhost virtualization-options interfaces ge-1/0/x mapping interface hsxex command. After you change the the mapping, FPC1 restarts automatically.