Configuring an MPLS Layer 2 Circuit (CLI Procedure)
To configure a Layer 2 circuit on a PE router:
- Enable a Layer 2 circuit on the appropriate interface. [edit]user@host# edit protocols l2circuit neighbor interface-name interface interface-name
- Enter the circuit ID number. [edit protocols l2circuit neighbor interface-name interface interface-name]user@host# set virtual-circuit-id id-number
For neighbor, specify the local loopback address, and for interface, specify the interface name of the remote PE router.
- Commit the configuration if you are finished configuring
the device. [edit]user@host# commit