Help us improve your experience.

Let us know what you think.

Do you have time for a two-minute survey?

 

Configuring Aggregated Ethernet LACP (CLI Procedure)

 

For aggregated Ethernet interfaces on EX Series switches, you can configure the Link Aggregation Control Protocol (LACP). LACP is one method of bundling several physical interfaces to form one logical interface. You can configure aggregated Ethernet interfaces with or without LACP enabled.

LACP was designed to achieve the following:

  • Automatic addition and deletion of individual links to the bundle without user intervention

  • Link monitoring to check whether both ends of the bundle are connected to the correct group

Note

You can also configure LACP link protection on aggregated Ethernet interfaces. For information, see Configuring LACP Link Protection of Aggregated Ethernet Interfaces for Switches.

The Junos OS implementation of LACP provides link monitoring but not automatic addition and deletion of links.

Before you configure LACP for EX Series, be sure you have:

When LACP is enabled, the local and remote sides of the aggregated Ethernet links exchange protocol data units (PDUs), which contain information about the state of the link. You can configure Ethernet links to actively transmit PDUs, or you can configure the links to passively transmit them (sending out LACP PDUs only when they receive them from another link). One side of the link must be configured as active for the link to be up.

Note

Do not add LACP to a LAG if the remote end of the LAG link is a security device, unless the security device supports LACP. Security devices often do not support LACP because they require a deterministic configuration.

To configure LACP:

  1. Enable the LACP mode:
    [edit interfaces]

    user@switch# set aex aggregated-ether-options lacp mode

    For example, to specify the mode as active, execute the following command:

    [edit interfaces]

    user@switch# set aex aggregated-ether-options lacp active
    Note

    LACP decides active and back up state of links. When configuring LACP, state of the backup link should not be configured manually as down. The following command is not supported if LACP is configured:set interfaces ae0 aggregated-ether-options link-protection backup-state down

  2. Specify the interval and speed at which the interfaces send LACP packets:
    [edit interfaces]

    user@switch# set aex aggregated-ether-options lacp periodic interval

    For example, to specify the interval as fast, execute the following command:

    [edit interfaces]

    user@switch# set aex aggregated-ether-options lacp periodic fast
Note

The LACP process exists in the system only if you configure the system in either active or passive LACP mode.