Configuring Two EPD Thresholds per Queue
For ATM2 IQ interfaces configured to use Layer 2 circuit trunk mode, you can set two EPD thresholds that depend on the PLPs of the packets. When you set a threshold with the epd-threshold statement, it applies to packets that have a PLP of 0. When you set a threshold with the plp1 statement, it applies to packets that have a PLP of 1. If you include the plp1 statement in the configuration, you must also include the epd-threshold statement.
To configure two EPD thresholds, include the epd-threshold and plp1 statements:
You can include these statements at the following hierarchy levels:
[edit interfaces interface-name atm-options scheduler-maps map-name forwarding-class class-name]
[edit interfaces interface-name unit logical-unit-number]
[edit logical-systems logical-system-name interfaces interface-name unit logical-unit-number]
The value you set with the epd-threshold statement (for PLP0) should be equal to or greater than the value you set with the plp1 statement. EPD threshold ranges vary by interface type. See EPD Threshold Range by Interface Type.
For general information about EPD thresholds, see Configuring the ATM2 IQ EPD Threshold.