Assigning CoS Components to Interfaces (J-Web Procedure)
This topic applies only to the J-Web Application package.
J-Web Application package Release 14.1X53-A2 does not support Class of Service (CoS) on EX4600 switches.
After you have defined CoS components on an EX Series switch, you must assign them to logical or physical interfaces. You can use the J-Web interface to assign scheduler maps to physical or logical interfaces and to assign forwarding classes or classifiers to logical interfaces.
To assign CoS components to interfaces:
- Select Configure > Class of Service > Assign to Interface.
After you make changes to the configuration on this page, you must commit the changes immediately for them to take effect. To commit all changes to the active configuration, select Commit Options > Commit. See Using the Commit Options to Commit Configuration Changes (J-Web Procedure) for details about all commit options.
- To configure an interface association, select an interface from the list and click Edit. For an EX8200 Virtual Chassis configuration, select the member, the FPC, and the interface from the list, and click Edit.
- Select one of the following:
Associate system default scheduler map—Associates the interface with the default scheduler map.
Select the scheduler map—Associates the interface with a configured scheduler map. Select the scheduler map from the list.
On the 40-port SFP+ line card for EX8200 switches, you cannot commit your changes using the J-Web interface unless you assign the same scheduler map or the default scheduler map to all interfaces in a port group.
- Click OK.
- To manage a CoS assignment on a logical interface, Click one of the following options:
Table 1: Assigning CoS Components to Logical Interfaces
Specifies the name of a logical interface. Enables you to assign CoS components when you configure a logical interface on a physical interface.
Type the interface name.
To assign CoS to all logical interfaces configured on this physical interface, type the wildcard character (*).
Assigns a predefined forwarding class to incoming packets on a logical interface.
To assign a forwarding class to an interface, select the forwarding class.
Enables you to apply classification maps to a logical interface. Classifiers assign a forwarding class and loss priority to an incoming packet based on its CoS value.
To assign a classification map to an interface, select an appropriate classifier for each CoS value type used on the interface.
Enables you to alter the CoS values in outgoing packets to meet the requirements of the targeted peer. A rewrite rule examines the forwarding class and loss priority of a packet and sets its bits to a corresponding value specified in the rule.
Note: In EX4300 switches, this option is available only when you click Edit button in the Configure Interface Association table.
To assign rewrite rules to the interface, select the appropriate rewrite rule for each CoS value type used on the interface.