Statement introduced in Junos OS Evolved Release 19.3R1.
Hierarchy introduced in Junos OS Evolved Release 20.1R1 for JNP10K-LC1201 line card on PTX10008 routers.
(PTX10003-80C and PTX10003-160C routers) While setting port 0 to 400-Gigabit Ethernet mode (using QSFP56-DD-400GBASE-LR8 optics), the total bandwidth (speed x number-of-subports) of port 1 has to be less than 100G and port 2 has to configured as 'unused'. When using port 4 as 400G, port 3 has to be configured with total bandwidth and port 2 has to be configured 'unused'. Similarly, with port 5, 9 using 400G, port 6, 8 respectively has to be configured for less than 100G and port 7 should be configured as 'unused'. That is, when a port is configured in 400-Gigabit ethernet mode, you cannot configure speed of the adjacent port to be more then 100-Gbps, and the middle port (2 between 0~4 or 7 between 5~9) must be set to unused. To set a particular port to unused port, use unused CLI command.
You cannot use port 1,3,6 and/or 7 of the same logical PIC.
Refer to Configuring 400-Gigabit Ethernet Interfaces on PTX10003 Routers for more information.
(JNP10K-LC1201 on PTX10008 routers) To disable the specified physical port in a PIC. If you disable a port, no interfaces (channelized or non-channelized) are created for the port, irrespective of the port profile configuration configured on the port.
The edit chassis hierarchy is available in 20.2R1 Release on PTX10001-36MR. From 20.3R1 onwards you must use only the edit interfaceinterface-name hierarchy.
Required Privilege Level
interface—To view this statement in the configuration.
interface-control—To add this statement to the configuration.